Home
Albany Ultrasmart Controller Operation Manual

Albany Ultrasmart Controller Operation Manual

февраля 12 2021

Albany Ultrasmart Controller Operation Manual

Download Owner's manual of Albany 570 Door, Garage Door Opener for Free or View it Online on All-Guides.com.

Albany Ultrasmart Controller Operation Manual Free

Download 11 Albany Door PDF manuals. User manuals, Albany Door Operating guides and Service manuals. CONTROL SYSTEM The door is operated with the powerful Albany MCCcontrol system that allows highly dynamic door operation with an opening speed of up to 2,0 m/s and a closing speed of up to 1,2 m/s, resulting in very short cycle times. The Albany RP2000 door is designed for continuous operation with up to five cycles per minute. Version 1.3 Manual #001011 6 Albany High Speed Doors Operation DO NOT reset the door until the break away flap(s) are out of the side rails on th eside away from Download Ultrafabric Doors W/ Ultrasmart Operation - Albany document. Setting, the switch contacts will open and activate a timer in the control panel (set at 1 minute). If the system operating pressure stays below the low pressure set point for the full minute, the pumping system will stop. A fault light on the panel will serve to alert the operator. The system will REMAIN STOPPED until the MANUAL RESET on the.

Brand: Albany

Category: Door , Garage Door Opener

Type: Owner's manual

Model: Albany 570 , Albany RapidRoll 670

Pages: 56 (2.97 Mb)

Part Number 6410T0006 Version 4/23/2010
The motor brake is located inside the fan cover compartment of the motor. It can be accessed by
removing the fan cover. Refer to Figure 28 while following this procedure.
WARNING
MAKE SURE THE DOOR IS POWERED DOWN AND LOCKD OUT BEFORE REMOVING THE
FANCOVER. THIS IS TO ASSURE THAT THE MOVING MOTOR PARTS ARE NOT EXPOSED
Software
1.Remove the fan cover
3.Set the air gap “T” (referred to Figure 28) to 0.3mm by adjusting the screw referred to in Figure 28
4.Tighten nut (referred to in Figure 28as item 6) to lock in the gap setting.
5.Verify that the gap “X” (referred to Figure 28) is a minimum of 1.0mm by adjusting the nut shown.
Perform this procedure whenever the gap “T” grows above 0.45mm.
Albany ultrasmart controller operation manual free

Related Products for Albany RapidRoll 670

Albany Ultrasmart Controller Operation Manual Online

Related Manuals for Albany RapidRoll 670

Albany Ultrasmart Controller Operation Manual Download

Albany RapidRoll 670: Frequently viewed Manuals

Albany Ultrasmart Controller Operation Manual

Leave a Reply

Cancel reply